How to Install: 2020-2022 F-250 SS5 Grille CrossLink LED Lightbar Kit

SS5 LED Pod Light Bar Bumper Kit on Ford F250 Super Duty
March 21, 2023 | Print this Page
How to Install: 2020-2022 F-250 SS5 Grille CrossLink LED Lightbar Kit

The SS5 Grille CrossLink LED Lightbar Kit adds a high-power LED pod light bar to your 2020-2022 Ford Super Duty bumper. The following installation guide will provide you with step-by-step instructions on how to install the SS5 Grille CrossLink Lightbar Kit.

Installation Tools

Mounting Instructions

Step 1 - Remove Grille Clips

Using a trim removal tool, remove the 4 push tabs and 4 tree clips securing the front grille.

Grill Plastic Clip Removal

Step 2 - Remove Plastic Trim 

Pull the plastic trim away from the vehicle to expose the inside of the front bumper/grille.

Expose the inside of front bumper

Step 3 - Expose Mounting Holes

Pry up the plastic trim on the front bumper using the plastic trim removal tool to expose the mounting holes for the bracket. You may need to reach under the bumper and squeeze the trim clips together to loosen them.

Expose mounting holes for the bracket

Step 4 - Install Mounting Bracket

Install the bracket as shown below with the six 13mm bolts, 13mm nuts, and washers provided in the kit.

Install bracket

Wiring Instructions

Step 5 - Route DT Connector

On the passenger side of the vehicle, feed the 4-pin female DT connector down towards the fog lights. 

DT connector line

Step 6 - Loosen Inner Fender Liner

Remove the 10mm bolt and the plastic clip holding the inner fender liner. 

bolt and plastic clip on fender

Step 7 - Route DT Connector Through Fender Liner

Find the female DT connector and pull enough slack so that the connector will reach the front passenger grille bracket.

Female DT connector line

Step 8 - Route DT Connector To Grille

Feed the female DT connector to the opening of the grille as seen in the picture below.

feed DT Connector towards grille

Step 9 - Route DT Connector Through Grille

Pull enough of the wire harness through to connect the female DT connector to the SS5 CrossLink light bar and tuck the rest away.

Assemble the SS5 CrossLink Kit

Step 10 - Link SS5 LED Pods 

Assemble your SS5 lightbar using the CrossLink lightbar instructions. When you assemble the SS5 lightbar, use the 2nd notch on the links as shown in the picture below.

CrossLink connector

Step 11 - Install CrossLink Light Bar

Install the wiring harness and route all wiring, following the included wire harness instructions.

Install 6-pod SS5 CrossLInk light bar.

complete installation

Step 13 - Reinstall the Grille

Reinstall the Grille by reversing steps 1-2.

Step 14 - Complete Installation

Secure the wires, test thoroughly, and tighten all hardware to complete your installation.


Questions About the Installation?

If you have any questions or issues installing the SS5 Grille CrossLInk Lightbar Kit for 2020-2022 Ford Super Duty, please contact us for further information.

Where Can I Buy an SS5 Grille CrossLink Lightbar Kit for 2020-2022 Ford Super Duty?

If you're ready to upgrade your 2020-2022 Ford Super Duty with an SS5 CrossLink Grille Kit, you can purchase one by clicking here or using our dealer locator to find a dealer near you. 

Want to know more about Diode Dynamics products? Visit DiodeDynamics.com and subscribe to our newsletter for new product releases and more!

This Installation Guide is for the following SKUs: DD7570, DD7571, DD7572, DD7573, DD7574

Previous article:
Next article: