The Stage Series LED Chase Light Kit and the Stage Series LED Reverse Light Kit for the 2014-2023 Polaris RZR XP allow you to mount two SSC2 LED pods on the rear of the factory roll bar without the need for any cutting or drilling.
The following installation guide will provide you with detailed instructions on how to install the Stage Series LED Chase Light Kit and LED Reverse Light Kit. Check out our installation video, or continue reading for step-by-step instructions below!
Table of Contents
Installation Video
Installation Tools
- 3/8" Ratchet
- 10mm Socket
- 10mm Wrench
- 3/8" Wrench
- 5/32 Allen Key
- 3/16 Allen Key
Mounting Instructions
Step 1 - Attach Roll Bar Mount
Take the roll bar mount, slide the ring over the bar, and secure the mounting platform (circled in red) by using the included long 3/16 allen bolt, washers, and nut.
Step 2 - Mount SSC2 Universal Brackets
Take the universal SSC2 U-bracket and bolt it in place using the included washer and bolt with the roll bar mount.
Step 3 - Mount SSC2 Pods
Bolt the SSC2 to the universal bracket using the supplied 5/32 allen bolt and nut. Tighten everything down using a 5/32 allen and 3/8th wrench, repeat these steps on the other side.
Step 4 - Adjust the Driver's Seat
Inside the vehicle, position the driver's seat to gain access to the battery. Reach in between the driver's seat to lift the release level on the back side, then pull the seat up (blue arrow) and lean it forward (red arrow).
Step 5 - Connect Battery
Use a 10mm socket to connect the red wire from our harness to the positive battery terminal and the black wire to the negative battery terminal. Then tuck the relay next to the battery so it is out of the way.
Step 6 - Route Wiring Harness
Take the DT connectors and route them up the back of the vehicle and across into the back of the SSC2 LED pods on both sides (as shown).
Step 7 - Test For Function
Test for functionality. Then, zip tie loose wiring up and out of the way how you see best fit.
Step 8 - Mount Switch
Mount the toggle switch to the location of your choice, for this installation, we zip-tied the switch up and away since it’s not our vehicle to modify.
Step 9 - Reassemble RZR
Resecure everything, reversing the steps used to take it apart.
The installation is now complete. Enjoy your new Stage Series Chase Light or Reverse Light Kit!
Questions About the Installation?
If you have any questions or issues installing the Stage Series Chase Light Kit or the Stage Series Reverse Light Kit, please contact us for further assistance.
Where Can I Buy a Stage Series Chase or Reverse Light Kit for the 2014-2023 Polaris RZR XP?
If you’re ready to upgrade your 2014+ Polaris RZR XP with a Stage Series LED Chase or Reverse Light Kit, you can purchase one by clicking here or by using our dealer locator to find a dealer near you.
Want to know more about Diode Dynamics products? Visit DiodeDynamics.com and subscribe to our newsletter for new product releases and more!
This Installation Guide is for the following SKUs: DD6818, DD7734, DD7735, DD6818, DD7736, DD7737
Share This Post