Add significantly more light output when backing up at night with our Stage Series HitchMount Reverse Light Kit! This kit allows you to mount one SSC1 LED pod in your 2-inch trailer hitch receiver, adding a high-power reverse light and additional running light. The included harness plugs right into your factory tail light wiring for easy installation and operation. Continue reading for step-by-step instructions below!
Table of Contents
Installation Video
Installation Tools
- Ratchet
- 7mm Socket
- 8mm Socket
- Zip Ties
Wiring Instructions
Step 1 - Remove Driver Side Tail Lamp
At the back of the truck, drop the tailgate and locate the drive-side tail lamp. There will be two (2) 8mm screws holding it in place that we'll be removing using a ratchet and 8mm socket.
Step 2 - Disconnect Factory Tail Lamp
Once the two bolts are removed, firmly tug to remove the tail lamp from the body of the vehicle, and then disconnect the factory harness by pressing on the release tab.
Step 3 - Plugging in Reverse Light Wiring Harness
Taking the included harness in our kit, feed the DT connectors down through the tail light pocket until the in-line adaptor is left and plug it in-line.
Repeat these steps on the other side of the vehicle.
Step 4 - Re-Installing the Factory Tail Lamp
Snap the tail lamp back in place and secure it using the two (2) factory 8mm screws.
Step 5 - Routing the DT Connectors
Underneath the vehicle, you'll notice our harness with our DT connectors. The harness and DT connectors will need to be routed over the driver's side bed support to keep away from the exhaust.
Note: If you decide to plug our harness into the passenger-side tail lamp, you'll need to remove the (8) 7mm bolts holding on the splash guard then pull it back to gain access to the DT connector apart from our harness.
Step 6 - Routing DT into Hitch Receiver
Now, take the DT connector and feed it into the back of your hitch receiver opening to the back of the truck.
Step 7 - Installing C1 HitchMount LED Pod
With your DT connector fed through your receiver, plug it into your C1 HitchMount LED pod, slide your HitchMount into your receiver, and ensure the tabs on the side of the snap-fit housing lock into place.
Step 8 - Test for Function
With our C1 HitchMount LED Pod connected, test to ensure the function of the red running lights along with the white reverse light feature. With everything operating properly, be sure to go back and zip-tie up any loose wiring and ensure all hardware is secure.
The installation is now complete. Enjoy your HitchMount LED Pod Reverse Light Kit for the 2022-2024 Ford Maverick!
Questions About the Installation?
If you have any questions or issues installing the HitchMount LED Pod Reverse Kit for the 2022-2024 Ford Maverick, please contact us for further assistance.
Where Can I Buy a HitchMount LED Pod Reverse Kit for the 2022-2024 Ford Maverick?
If you’re ready to upgrade your 2022-2024 Ford Maverick with a HitchMount LED Pod Reverse Kit, you can purchase one by clicking here or using our dealer locator to find a dealer near you.
If you are looking to add additional Off-Road LED Lights to your Maverick, we have a variety of LED Light bars and Pod Light kits here!
Want to know more about Diode Dynamics products? Visit DiodeDynamics.com and subscribe to our newsletter for new product releases and more!
This Installation Guide is for the following SKUs: DD7766
Share This Post